![]() The ADOR1 Auto Chicken Door looks at the ambient light level outside and averages it over time. After all, experience dictated that the door closes a little late because some chickens do not go in right away. We think the factory setting on the light level is sufficient for most cases, but you can change the timing yourself if you want to. We have performed tests on individual ADOR1 units to see which parts wear out if any. After the equivalent of more than 35 years of continuous open/close action, there was no visible wear on the mechanism. In addition, there were no outwardly visible signs of wear on the motor. We continue to do more tests as part of our product development and improvement. The ADOR1 product is currently in its 6th year with an excellent track record.Īll you do is remove the ADOR1 from the shipping box. Next, open the cover (two screws) and connect the battery. ![]() Finally, clip the wires to the terminals on the battery. It is easiest if you mount the frame on an existing wall. It's as easy as mounting a picture on a wall. Just put one screw in each of the four corners of the ADOR1. Use the ADOR1 as a template to mark where to cut the opening. Then, jog the door up and down with the pushbutton, so the door moves away from the mounting holes. You should have a drill, a level, and a saw if you need to make the opening and a screwdriver. If you already have an opening in the coop, you may only need to mount the ADOR1 to cover the opening. When making a new opening, this is how you do it: First, from inside the coop, drill a hole in the exterior wall about an inch or two above the coop floor. By mounting the door up a little bit, it will help keep chicken scratch from obstructing where the door comes down and seals out the vermin and predators. Go outside and hang the frame like you would hang a picture. Trace the opening with a pencil, remove the frame, saw the opening by following the pencil mark.Ĭan I mount it to the inside wall instead of the outside wall? Start a screw in the top mounting hole of the frame.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |